Real Life Incident: Control Your Control Wire

A vessel’s lifeboat with crew on board was being lowered to the water when the remote control lowering wire suddenly parted. Poor winch wire spooling under the outer layers led to a wire kink, creating a weak spot that contributed to the wire failure. The consequences in this instance were not serious, as the broken wire simply meant the brake was re-applied. However, had this been a real abandon ship, the consequences could have been more serious.

The remote control wire was replaced with an extra wire found on board, and another test was carried out the next day. The lifeboat crew boarded and the coxswain used the remote control wire to lift the brake and begin the descent. Again, the control wire failed to spool smoothly, and an unexpected pay-out of the control wire led to the winch brake prematurely engaging. The lifeboat stopped lowering and swung erratically above the embarkation deck.

Seconds later, the swinging motion caused the wire to regain tension. This lifted the winch brake arm and caused the lifeboat to lower again, still swinging. As the lifeboat swung, the skeg keel caught on the deck edge, and the lifeboat listed by more than 90°, as seen in the photo. A crewmember on deck quickly activated the winch brake lever to save the situation. Had the lifeboat inverted further the consequences could have been catastrophic.

An internal company investigation identified that the crew did not follow existing company policy, which required a test lowering without crew prior to embarking crew. The company’s policy is based on the recommendations contained within MSC.1-Circ.1578, Guidelines on Safety During Abandon Ship Drills Using Lifeboats. While a ‘test owering’ may not have prevented these incidents, it would have provided an opportunity to identify the poor spooling of the wire and prompted corrective action without risk to crew.

owering’ may not have prevented these incidents, it would have provided an opportunity to identify the poor spooling of the wire and prompted corrective action without risk to crew.

Lessons learned

Ship’s crew should conduct a thorough visual inspection of lifeboat launching systems and perform a test lowering before carrying out operations with crew on board. Pay special attention to the following inspection points:

• Verify the proper spooling of the remote control wire, expand inspection as necessary.
•  Verify that the remote control wire weight is in the correct position. If the weight is very close to the top of the lifeboat, this may indicate the remote control wire is too long.
• Verify the material condition of the shackle that connects the pull cable to the remote control wire within the lifeboat. These steel shackles can corrode and may be overlooked during weekly/monthly/ annual inspections

Reference: The Nautical Institute

About Author

Marine Insight News Network is a premier source for up-to-date, comprehensive, and insightful coverage of the maritime industry. Dedicated to offering the latest news, trends, and analyses in shipping, marine technology, regulations, and global maritime affairs, Marine Insight News Network prides itself on delivering accurate, engaging, and relevant information.

Read more articles by this author

Latest Case studies Articles You Would Like:

Hydraulic Oil Leak Starts Fire in Engine Room

Real Life Incident: Grounding Leads To Major Listing Of Ship, Declared Total Constructive Loss

Real Life Incident: Unattended Incinerator Catches Fire In Cooling-Off Period

Real Life Incident: CO2 Labelling Mixup

Real Life Incident: Near Collision Between Two Vessels With Distance Of 35 Meters

Real Life Incident: Ferry Trip Ends With U-Turn Into Shore